9. OTHER FUNCTIONS
9-18
9.7 How to Set Dual Configuration
You can configure two dual differential GPS navigator systems and an interface unit.
1. Press the MENU/ESC key to open the main menu.
2. Select [7 I/O] then [8 Dual].
3. Select [1 No], [2 Serial (Data2)] or [3 Ethernet].
[No]: Don’t set dual configuration.
[Serial (Data2)]: Sets dual configuration using data2.
[Ethernet]: Sets dual configuration using Ethernet.
4. Press the MENU/ESC key to close the main menu.
9.8 How to Set ECDIS Sync Configuration
When connecting the ECDIS (FMD-3x00 series) via LAN, you can display the ECDIS-
set monitored route on the display of the GP-170.
1. Press the MENU/ESC key to open the main menu.
2. Select [3 Navigation] then [4 ECDIS Sync].
3. Select [2 ECDIS IP ADR].
4. Enter the IP address for the connected ECDIS with the numeric keys.
5. Move the cursor to [Enter] then press the NU/CU ENT key.
6. Select [3 ECDIS SFI].
7. Press the ACK/DELETE key to move the cursor to the leftmost of the input posi-
tion.
8. Enter the SFI for the connected ECDIS with the cursorpad and the numeric keys
(combination of two alphabets and four numerals).
9. Move the cursor to [Enter] then press the NU/CU ENT key.
Backspace
Press the
ACK/DELETE key.
To Next Page
Loading...
