6. NOTICES
6-2
3. Select [1 Notice Sound].
4. Select [1 Off], [2 On] or [3 Continuous].
[Off]: No sound, only visual notice (an icon turns blue)
[On]: Three long beeps and visual notice (related icon turns
blue)
[Continuous]: This buzzer sounds until the ACK/DELETE key is operated to ac-
knowledge the notice. Visual notice (related icon turns blue).
5. Press the MENU/ESC key to close the main menu.
6.2 Arrival/Anchor Notice
Note: You can not set both arrival and anchor notices at the same time.
6.2.1 Arrival notice
The arrival notice alerts you when you are within the specified distance from a desti-
nation waypoint.
Before setting arrival notice, set the arrival radius (see "Arrival radius" on page 4-2).
1. Press the MENU/ESC key to open the main menu.
2. Select [4 Notice Setting] then [1 Arrival/Anchor].
3. Select [1 Arrival]. The arrival notice icon ( ) appears in gray
at the top right-hand corner of the display.
4. Press the MENU/ESC key to close the main menu.
To turn off the arrival notice, select [3 Off] at step 3.
6.2.2 Anchor notice
The anchor notice alerts you that your ship is moving when your ship should be at rest.
Before setting anchor notice, set the arrival radius (see "Arrival radius" on page 4-2).
Notice setting
Destination waypoint
: Notice zone
Your ship
Notice setting
Destination waypoint
: Notice zone
Your ship
To Next Page
Loading...
