3. MARKS
3-3
3. With the cursor on the [New] line, press the NU/CU ENT key.
4. Select [1 Cursor].
5. Use the cursorpad to select the position for the mark.
6. Press the NU/CU ENT key.
7. Change the name (see page 4-6), position, symbol or color if necessary.
8. Select [9 Register]. The confirmation message appears.
9. Select [1 Yes] or [2 No].
[Yes]: Marks are registered with connection lines.
[No]: Marks are registered without connection lines.
10. Press the MENU/ESC key to close the main menu.
By entering L/L
1. Press the MENU/ESC key to open the main menu.
2. Select [3 Navigation] then [1 Mark Registration].
3. With the cursor on the [New] line, press the NU/CU ENT key.
To Next Page
Loading...
