GE AKTA avant - Page 106

1
2
3 4
FunctionPart
UniNet-9 connectors (one connector is occupied by the Conductivity
monitor)
1
Network connector (Ethernet)2
Test point for service.3
Power input connector4
NOTICE
Do not connect any module to the connector Test on the ÄKTA
avant instrument.
Plug all unused UniNet-9 ports on the ÄKTA avant instrument with jumpers.
Note:
The connector Test should be protected by a plastic lid. Do not plug the con-
nector with a jumper.
Note:
106 ÄKTA avant User Manual 29035184 AE
4 Optional instrument modules
4.2 Installation of optional modules