7.7 Calibration procedures
About this chapter
This section provides instructions for calibration procedures that can be performed using
the System Control module in UNICORN software.
In this section
This section contains the following subsections:
See pageSection
3217.7.1 Calibrate the pH monitor
3237.7.2 Calibrate the pressure monitors
3277.7.3 Calibrate the Conductivity Monitor
3317.7.4 Calibrate the UV monitors
Open the Calibration dialog box
Open the System Control module. On the System menu, click Calibrate to open the
Calibration dialog box.
320 ÄKTA avant User Manual 29035184 AE
7 Maintenance
7.7 Calibration procedures
To Next Page
Loading...
