5.1 Before you prepare the system
Introduction
It is important to prepare the standard system in accordance with the settings in the
method to be run. Before preparing the system, check the settings in the Method Editor
and make sure that all accessories to be used are available.
Checklist
Make sure to prepare the system in accordance with the settings in the method to be
run. Make sure that you understand:
•
which valve ports to use for inlets and outlets
•
which column type to use
•
which column position to use
•
which buffers and samples to prepare
•
which sample application technique to use
•
that the pH electrode is connected and calibrated, if applicable
•
which cassettes with corresponding deep well plates and/or tubes to use in the
Fraction collector, if applicable
156 ÄKTA avant User Manual 29035184 AE
5 Operation
5.1 Before you prepare the system
To Next Page
Loading...
