GE AKTA avant - Prepare Fraction Collector F9-R

5.8.2 Prepare Fraction collector F9-R
Introduction
This subsection describes how to prepare and assemble Fraction collector F9-R before
a run.
Fraction collector F9-R can be connected to ÄKTA avant and controlled by UNICORN.
The fraction collector can be automatically controlled in a method run or manually
controlled.
Prepare the fraction collector
Before starting to prepare the Fraction collector F9-R, check the fractionation settings
in the method to be run. Perform the steps described below according to the settings in
the method.
•
Assemble the Tube rack
•
Insert collection tubes
•
Adjust the Delivery arm
•
Update System Settings in UNICORN
Illustration of the tube rack
FunctionPart
Single cutout1
L-shaped cutout2
Bowl3
Tube support4
Tube guide5
Tube holder6
1
2
3
4
5
6
Note that the tube guide has both single and L-shaped cutouts, while the tube
holder only has single cutouts.
Note:
210 ÄKTA avant User Manual 29035184 AE
5 Operation
5.8 Fractionation
5.8.2 Prepare Fraction collector F9-R