GE AKTA avant - Prime Inlets and Purge Pump Heads

5.4 Prime inlets and purge pump heads
About this section
Before usage of a pump, it is important to:
•
Prime the inlets (fill the buffer inlets with liquid).
•
Purge the pump (remove air from the pump heads).
This section describes how to prime inlets and purge the pump heads of the system
pumps and the sample pump.
Note that the procedures described in this section may have to be adapted if
your system configuration differs from the one described in this manual.
Note:
In this section
This section contains the following subsections:
See pageSection
1665.4.1 Prime buffer inlets and purge system pumps
1735.4.2 Prime sample inlets and purge Sample Pump
1785.4.3 Prime Q inlets
ÄKTA avant User Manual 29035184 AE 165
5 Operation
5.4 Prime inlets and purge pump heads