GE AKTA avant - System Settings - Watch Parameters

9.7.8 System settings - Watch parameters
The following table describes the watch parameter settings available for ÄKTA avant.
DescriptionInstruction name
Sets the accepted signal fluctuation and Delta peak
limit of the UV signal for some of the tests in the
Watch:Watch and Watch:Hold until instructions.
Watch UV parameters
Sets the accepted signal fluctuation and Delta peak
limit of the UV 2nd signal for some of the tests in the
Watch:Watch and Watch:Hold until instructions.
Watch UV 2nd parame-
ters
Sets the accepted fluctuation and Delta peak limit of
the conductivity signal for some of the tests in the
Watch:Watch and Watch:Hold until instructions.
Watch cond parameters
Sets the accepted fluctuation and Delta peak limit of
the signal from the second conductivity monitor for
some of the tests in the Watch:Watch and Watch:Hold
until instructions.
Watch cond 2nd parame-
ters
Sets the value for the accepted fluctuation of the pH
signal used for the test Stable signal in the instructions
Watch:Watch and Watch:Hold until.
Watch pH parameters
Sets the value for the accepted fluctuation of the flow
rate signal used for the test Stable signal in the instruc-
tions Watch:Watch and Watch:Hold until with signal
System flow.
Watch flow parameters
Sets the value for the accepted fluctuation of the pres-
sure signals used for the test Stable signal in the instruc-
tions Watch:Watch and Watch:Hold until.
Watch pressure parame-
ters
Sets the accepted signal fluctuation and Delta peak
limit of the analog signal for some of the tests in the
Watch:Watch and Watch:Hold until instructions.
Watch analog in parame-
ters
ÄKTA avant User Manual 29035184 AE 471
9 Reference information
9.7 System settings
9.7.8 System settings - Watch parameters