GE AKTA avant - Replace Tubing and Connectors

7.8.1 Replace tubing and connectors
Maintenance interval
Replace tubing and connectors when required, for example when a tubing has clogged
or has been bent so that the flow is stopped.
Required material
The following materials are required:
•
Tubing and connectors
•
Tubing cutter
•
Fingertight wrench
Instruction
Follow the instruction below to replace tubing and connectors.
ActionStep
Make sure that no run is in progress on the instrument.1
Unscrew the connectors, and disconnect the tubing.2
If the tubing has labels, remove the labels to be used with the new tubing
later. Discard the tubing and connectors.
3
336 ÄKTA avant User Manual 29035184 AE
7 Maintenance
7.8 Replacement procedures
7.8.1 Replace tubing and connectors