ActionStep
Remove the outer locking O-ring from the top section.3
Lift up the top section of the Mixer and pull away the old O-ring inside.4
Wet the new O-ring with 20% ethanol and fit it in position. Make sure that
the inline filter is still in position.
5
Reassemble the Mixer components and, while holding the Mixer upright,
screw the top section back onto the Mixer.
6
ÄKTA avant User Manual 29035184 AE 341
7 Maintenance
7.8 Replacement procedures
7.8.3 Replace the O-ring inside the Mixer
To Next Page
Loading...
