GE FVP110 - Parameters of AO Block; AO Block Parameters

FVP 110 Fieldbus Valve Positioner Manual
198
GE Energy
Parameters of AO Block
113 2113 SERVO_
TIME_TH
10 sec High-limit alarm setting for total time of Servo
Output Drift warning.
114 2114 SERVO_
WARN_
COUNT
0 O/S Total number of times of Servo Output Drift
warning. To reset the count, write 0.
115 2115 X_BST_ON_
THRESHOLD
0, 0 % O/S The addition value to threshold for switching on
boost action; a control parameter for exhaust
[-10 to 10%]
Applicable for Double Acting Type
116 2116 X_BST_OFF_
THRESHOLD
0, 0 % O/S The addition value to threshold for switching off
boost action; a control parameter for exhaust
[-10 to 10%]
Applicable for Double Acting Type
117 2117 X_BOOST_
VALUE
0, 0 % of MV O/S The addition Boost value; a control parameter
for exhaust [-50 to 50%]
Applicable for Double Acting Type
Table 62 AO Block Parameters
Relative
Index
Index Parameter
Name
Default
(factory
setting)
Write Description
0 5000 Block Header Block Tag
=O/S
Information about this block, including the
block tag, DD revision, execution time
1 5001 ST_REV 0 — Incremented when a change is made to the
parameter settings for the AO block to indicate
the revision level of the settings, and used to
see whether there is a change in parameter
settings.
2 5002 TAG_DESC Spaces Universal parameter storing the description of
the tag
3 5003 STRATEGY 1 Universal parameter used by an upper-level
system to classify the function blocks
Table 61 Transducer Block Parameters (Continued)
Relative
Index
Index Parameter
Name
Default
(factory
setting)
Write Description