• Alarm Low-Low SP: Set point of the battery voltage Low-Low alarm condition.
• Alarm Low SP: Set point of the battery voltage Low alarm condition.
• Alarm Delay: Alarm delay for both set points.
• Alarm L-L Relay: Relay activated when a battery Low-Low alarm condition is
detected.
• Alarm Low Relay: Relay activated when a battery Low alarm condition is
detected.
Note: Do not adjust without consulting the General Electric Customer Service (the
coordinates can be found at the bottom of page 9).
A battery alarm is triggered if the voltage of the battery is below the Low or Low-
Low set point for a period of time longer than the delay. For details, see
Section 6.3.2.3.
Note: Appendix I presents the list of all alarm messages that can appear in the
Perception software.
For explanations pertaining to the Hydran M2-X’s battery, see Section 2.3.4.1; for
the battery specifications, see Section 9.3.1; to replace the battery, see Appendix G.
To Next Page
Loading...
