DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
Chapter 8 Replacement Procedures 8 - 81
Bulkhead Cover installation
3.
Pull the Bulkhead Cover away from the
system.
Bulkhead Cover Tabs (cover removed)
Table 8-97 Bulkhead Cover installation
Steps Corresponding Graphic
1.
Position Bulkhead Cover, tucking any cables within the cover to avoid pinching the cables.
2.
Install lower tab locks first, and then upper tab locks.
3.
Replace Bulkhead Cover.
Table 8-96 Bulkhead Cover removal
Steps Corresponding Graphic
To Next Page
Loading...
