DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
Chapter 8 Replacement Procedures 8 - 301
2.
Disconnect the from the Backplane:
the Batteries power J10 and J11, and the
signal/communication connections J13
and J14.
NOTE: The power J10 and J11
connections of the Batteries MUST BE
DISCONNECTED as part of the Energy
Control and Power Lockout for the
LOGIQ E10.
Remove the batteries.
3.
Remove the Main Power Supply.
4.
Free all the Boards in the Card Cage from the Backplane, including the ECB and EPM.
Table 8-329 Backplane removal
Steps Corresponding Graphic
To Next Page
Loading...
