ActionStep
If the clamp does not close automatically, gently push the bag clamp
opener upwards to secure the upper end of the Cellbag bioreactor. Do not
use force. Gently pull on the bioreactor to make sure it is attached.
3
Repeat the above steps to attach the lower Cellbag rod to completely secure
the Cellbag bioreactor on the tray.
4
Mount the lid on top of the tray.5
NOTICE
Keep the Cellbag bioreactor covered with the lid
throughout the cultivation to protect the optical sen-
sors from excessive light exposure.
ReadyToProcess WAVE 25 Operating Instructions 29009597 AD 113
5 Operation
5.1 Set up the system
5.1.4 Attach the Cellbag bioreactor
To Next Page
Loading...
