GE ReadyToProcess WAVE 25 User Manual

3.3 ReadyToProcess CBCU
Introduction
The control unit, ReadyToProcess CBCU, is connected to the rocker via a UniNet-9 con-
nector. The full configuration mixes air/N
2
, O
2
, and CO
2
gas, and contains O
2
and CO
2
sensors, a mass flow controller, an optical pH sensor reader, and an optical DO sensor
reader. Three configurations are available:
•
ReadyToProcess CBCU pH: CO
2
, O
2
and pH.
•
ReadyToProcess CBCU DO: CO
2
, O
2
and DO.
•
ReadyToProcess CBCU Full: CO
2
, O
2
, pH and DO.
For specifications of the CBCU, refer to the ReadyToProcess WAVE 25 System Handbook
or the data file for ReadyToProcess WAVE 25, available for download from
www.gelifesciences.com/wave.
Front view of ReadyToProcess
CBCU
The illustration below shows the front panel of a fully configured CBCU. The configuration
of your CBCU may vary from the configuration shown below.
1
4
2
3
52 ReadyToProcess WAVE 25 Operating Instructions 29009597 AD
3 System description
3.3 ReadyToProcess CBCU

GE ReadyToProcess WAVE 25 Specifications

General

Brand	GE
Model	ReadyToProcess WAVE 25
Category	Laboratory Equipment
Language	English