4.3 Software installation
About this section
This section describes how to perform a complete UNICORN 7.0 installation on a stand-
alone workstation (Full installation). Instructions on how to configure an e-license, define
a system, and set up a system printer are also included.
For other types of installations, contact your GE representative for support.
This includes network installations when you want to access the
ReadyToProcess WAVE 25 system from several client computers or control
more than one system from a single computer, or to run the system from a
third-party controller.
Note:
Additional information about software installation and configuration is available in the
UNICORN Administration and Technical manual.
In this section
See pageSection
914.3.1 Install UNICORN software
944.3.2 Configure an e-license
1014.3.3 Define the system
90 ReadyToProcess WAVE 25 Operating Instructions 29009597 AD
4 Installation
4.3 Software installation
To Next Page
Loading...
Need help?
General
