5.1.2 Attach and detach tray
This section describes how to attach and detach a tray to and from the rocker platform.
These operations should preferably be performed without a Cellbag bioreactor on the
tray.
CAUTION
Due to the size and weight of Tray 50, at least two persons are
recommended for installing the tray.
Attach tray
The tray can be attached to the rocker platform in tilt position and in normal position.
Tilt position is recommended, as described in the instructions below.
ActionStep
Tilt the rocker platform by pulling the upper edge towards you.1
Lift the tray into the same angle as the rocker platform.2
106 ReadyToProcess WAVE 25 Operating Instructions 29009597 AD
5 Operation
5.1 Set up the system
5.1.2 Attach and detach tray
To Next Page
Loading...
