GE ReadyToProcess WAVE 25 User Manual

5.1.4 Attach the Cellbag bioreactor
Instructions
Follow the instructions below to attach the Cellbag bioreactor to the tray.
When using a Cellbag bioreactor that only covers half of the tray in single
mode, such as a 10 L bag on Tray 20, position the bag on the left side of the
tray.
Note:
In dual mode, ensure that each Cellbag bioreactor is centrally positioned on
the respective grey heating pad. Weight measurement resolution will be
compromised if the bioreactor is not correctly placed.
Note:
ActionStep
Push the bag clamp openers in the upper corners of the tray downwards.
This opens the upper bag clamps.
Note:
For a Cellbag bioreactor that covers the whole tray, open both bag clamps.
In dual mode or with a bioreactor that covers only half the tray, only one
clamp needs to be opened.
1
Insert the upper Cellbag rod into the opened bag clamp.2
112 ReadyToProcess WAVE 25 Operating Instructions 29009597 AD
5 Operation
5.1 Set up the system
5.1.4 Attach the Cellbag bioreactor

GE ReadyToProcess WAVE 25 Specifications

General

Brand	GE
Model	ReadyToProcess WAVE 25
Category	Laboratory Equipment
Language	English