Install the client computer
equipment
Install the client computer equipment according to the manufacturer's instructions. The
computer is either supplied as part of the bioreactor system delivery or obtained locally.
IP settings for standalone installation
For a standalone installation, the client computer's network card that is connected to
the rocker should have the static IP 192.168.1.3. Refer to UNICORN Administration and
Technical manual, Appendix D for instructions on how to change these settings.
NOTICE
Any computer used with the equipment shall comply with IEC 60950
and be installed and used according to the manufacturer's instruc-
tions.
ReadyToProcess WAVE 25 Operating Instructions 29009597 AD 85
4 Installation
4.2 Hardware installation
4.2.1 Unpack the system units
To Next Page
Loading...
Need help?
General
