GE Reason H49 - Page 145

GE Reason H49
Technical Manual
H49/EN M/C22
145
12.1.4.3.2 Filtering
The following values can be set to configure filtering and redirection policy.
This command is also used to create rules to perform specific actions on specific Mac
addresses.
filtering <interface> -e <entry> -s <state> -a <MAC
address> -l <length> -t <type> -f <interfaces list> -p
<priority> -S -i
command parameter Description Values
filtering
-e
Sets the filter entry 4 to 9
-s
Sets the filter entry state enable, disable
-a
Sets the filter MAC Address xx:xx:xx:xx:xx:xx
-f
Sets the filter ports allowed (interfaces into which the
matching frame can be forwarded).
None
SE01
CE01
CE02
CE03
CE04
CE05
CE06
-l
Sets the filter length (mask length from the start of the MAC
addresses for incoming frame)
0 to 48
-t
Sets the filter type (the source or the destination MAC
address to compare).
scr, dst
-p
Sets the priority queue 0 to 3
-r
Displays reserved filter fields (to be used with –i)