GE Reason H49 - Page 153

GE Reason H49
Technical Manual
H49/EN M/C22
153
12.2.2.5 PTP
The example below shows the use of the ptp command line:
Command Description
ptp -m -l -f -p1 -p2 -a -s -c -
n
-S
Sets the IEEE1588-v2 PTP configuration i.e. the operating mode, delay,
profile, domain, and step together with the IEEE1588-v2 prority1 and 2,
the priority code point (PCP) of the PTP frames and the VLAN used.
Example:
ptp –m ordinary –l p2p –f power_2011 –p1 128 –p2 128 –a 0 –s 2 –c 4 –n 0 –s 1
12.2.2.6 Timezone
The examples below show the use of the timezone command line:
Example of command Description
timezone -z <time zone>
Sets the H49 time zone
Example:
timezone –z/Europe/Andorra
12.2.2.7 Banner Text
The examples below show the use of the bannertext command line:
12.2.2.7.1 Change Banner Text
Example of command Description
bannertext -M “message”
Updates the banner text with a message
Example:
bannertext –M “This is a banner text“