GFK-0356Q Chapter 2 Installation 2-9
2
■ IC693ACC313 Recessed Mount Adapter Bracket. Used to recess mount a baseplate inside
a 19” rack. A baseplate mounts on the rear panel of this adapter bracket using four 8-32
(4mm) screws, nuts, lock washers, and flat washers. The Adapter Bracket bolts through its
four slotted holes to the face of the 19” rack using applicable hardware (lock washers
recommended).
RIGHT SIDE OF
BASEPLATE
Insert two screws (1 at top; 1 at bottom)
from back of base unit through base unit
and bracket. Tighten screws to secure
bracket to base unit.
Note: Baseplate is shown with cover removed for illustration purposes. It
is not necessary to remove the baseplate cover to install the bracket.
Figure 2-7. IC693ACC308 Front Mount Adapter Bracket Installation
Dimensions for rack mounting a 10-slot baseplate with the IC693ACC308 Front Mount Adapter
Bracket are shown in the following figure.
DIMENSIONS IN INCHES (MILLIMETERS IN PARENTHESES)
18.89
(480)
18.47
(469)
Figure 2-8. Dimensions for 19-inch Rack Mounting Using IC693ACC308 Adapter Bracket
To Next Page
Loading...
