Gerber enVision User Manual

Advanced enVision Functions 47
Factory default settings
There are three levels of factory default settings that can be restored on the
enVision:

the default settings for the current material (See “Choosing Tool Settings”
on page 28.)

the default settings for all materials (below)

the defaults for all settings (below)
Reloading factory defaults for all materials
Note: All materials are reset to default settings. Custom materials are reset to
Scotchcal 220 settings.
1. Press F3 while holding down the ENTER key for the Operational Setup
menu.
2. Press F4, Misc. to get the Misc Settings menu.
3. On the Misc Settings menu, press F4, DEFAULT.
4. Press F3, YES to reset the settings for all materials to the factory defaults,
or F4, NO to return to the Misc Settings menu without making any changes.
Reloading factory defaults for all settings
Hold down the F1 and CANCEL keys while powering up the plotter to return all
settings to the factory defaults shown on the next page.
/+5% 5'66+0)5
4GRGCVU 2QWPEG
2WNNFQYP &GHCWNV
'06'4 HQT /CKP /GPW
(
4'5'6 #.. /#6'4+#.5
6Q &GHCWNVU! ;'5
01
;'5 ( VQ 4GUGV #NN
(
(
12'4#6+10#. 5'672
5GVVKPIU 5[UVGO
6GUV /KUE
'06'4 HQT /CKP /GPW
(

Gerber enVision Specifications

General

Max. image width	14.1 in (35.8 cm)
Resolution	203 dpi (8 dots/mm)
Print Resolution	203 dpi
Print Speed	Up to 3 ips
Maximum Print Width	14.1 in
Media Width	15 in
Media Thickness	0.01 in