Gerber enVision User Manual

66 enVision Owner’s Guide
2. Insert a flat tipped screwdriver into slotted cap, as shown in the illustration,
and rotate counterclockwise about ½ turn. Cap will release spring outward.
3. Take out cap and remove fuse.
4. Remove any blown fuse. The fuse rating is marked on the fuse itself. Be
sure to replace a blown fuse with a new fuse of identical size and rating.
5. Replace cap and using a flat tip screwdriver press inward until flush with
the carrier.
6. Turn ½ turn clockwise.

Gerber enVision Specifications

General

Max. image width	14.1 in (35.8 cm)
Resolution	203 dpi (8 dots/mm)
Print Resolution	203 dpi
Print Speed	Up to 3 ips
Maximum Print Width	14.1 in
Media Width	15 in
Media Thickness	0.01 in