46
Vapodest 50s carousel
9 Sample input
- Column ‘Auto sampler’
Only in use when the automatic auto sampler ‘Carousel’ is in use. The position
of the sample tubes in the sample carousel are dened.
Red number = this sample is processed next.
- Column ‘Method’
Anzeige des Methodenprogrammes, mit dem die Probe analysiert werden soll.
Durch Anklicken der 3 Punkte "..." in diesem Feld können Sie die Methodepa-
rameter einsehen.
- Column‘Blankvalue’– gives you the blank value obtained.
- Column ‘Rinsing’
You can determine whether the sample tube should be rinsed after the analysis
another time.
- Column ‘Sample name’ - You can dene a sample name
- Column ‘Sample type’
You can enter the type of sample, e.g. blank value, sample, standard, etc
- Column ‘Weight/volume’
Enter weight/volume of sample.
- Column ‘Unit’ - weight is entered in g, volume in ml
- Colum "Status"
Ready - The sample can be analysed, all data necessary for the
analysis are present
Finished - Sample has been analysed
Aborted - Analysis has been aborted without result
- Colum "Execution"
Highlight a eld in this column, then you can open a list with the following
options:
Execution: Sample is analyzed within the series.
Later: Sample table is not deleted at the end of the analysis so that
these sample can be analyzed at a later date as well (e.g. if
not all the data was present at the start of the series).
Ignore: Sample cannot be analyzed and will be skipped in the
next series.
As soon as the sample table is stored, you can start the analysis. In order to do
so, press ken "Start". Further information for running an analysis is located in
chapter "10 Execution of methods".
Press key "Close" to leave window sample table.
To Next Page
Loading...
