Removing and Installing pressure booster
Removing and Installing Pressure Booster
Observe safety and environmental information!
Wear safety goggles!
The device must be disconnected from the power and compressed air
supply!
Small Pressure Booster
- Remove cover on left from housing.
- Release plug connection from displacement sensor
(WS3) and screw connections, hold a rag under the
hydraulic pilot hose to collect the escaping oil.
- Unscrew mounting screw from mounting plate in base
of housing.
- Raise pressure booster and remove from housing.
- Install in reverse order of removal. The hydraulic sys-
tem for releasing the nosepiece must then be bled (see
Section 24 "Filling Hydraulic Systems").
To Next Page
Loading...
