Gesipa 8000 - Blow Air

9.6 Blow Air
GAV Settings
9.6 Blow Air
Basic setting of blow air
Undo adjusting screw of blow air control valve by 2
turns from the closed position.
Deviating settings:
- Less blow air due to damage to the blind
rivet caused by the feed system.
- More blow air in the event of defective blind
rivet feed or faulty mandrel ejection.
Blow air
Monitors the blow air runtime.
Runtime
Switches off the blower on reaching the set value.
Default
Resets all settings to default.
Cycle
Executes one processing cycle
(see Section 8.7 "Manual Operation" "Cycle" function).
Stroke
Moves riveting gun to stroke position
(see Section 8.7 "Manual Operation" "Stroke Position" function).
ON
Activates the blow air in GAV stroke position
(see Section 8.7 "Manual Operation" "Blow Air" function).
9
- 43 -
Navigation:
AUTO
►MAN
► Menu
► GAV settings
► Blow air
Blow air
settings menu
Blow air control
valve