golmar NEXA Series - Automatic Programming Mode for Monitors and Telephones (Plus y Vista Plus)

PROGRAM USING
START POSITION
SOFTWARE VERSION
QR MANUAL
PROGRAMMING THE DOOR PANEL
124
Shows the QR code of the door panel's instruction manual.
To display, press
.
SETTING RECORDED
System settings menu
Automatic programming mode for monitors and telephones :(Plus and Vista Plus)
SYSTEM CONFIG
ACCESS CONTROL
RESIDENT LIST
Start the monitor or telephone programming process as described on
35 36 39 40p. 1 and p. 1 or p. 1 and p. 1 respectively, with the difference
that, in this process, the door panel will automatically assign the code to
the monitor/telephone without having to interact with the door panel. Once
assigned and saved, the monitor/telephone will emit a number of
confirmation tones. It is not necessary to interact with the door panel.
Repeat the programming process for all of the system's monitors/
telephones.
To complete the process, press
.
N
ote: If the process is not completed, it can be resumed by changing the
START PROG setting and entering the required value.
Important: It is necessary to set AUTOMATIC PROG. to YES, as well as
PROGRAMME WITH and START PROG. before starting the process
(see p. 1 ).22
(Gtwin ).system without function
To enter configuration mode, press the key button
three times and then enter the secret administrator
pin (factory code 2718) as described on p. .117
CONFIGURATION
2 7 1 8
****
AUTO PROGRAMMING
000001
SETTING RECORDED
Continued from previous page
To save the changes, press .
AUDIO AND VIDEO DOOR ENTRY SYSTEM - CODED PANEL WITH DISPLAY
AUTO PROGRAMMING
PROGRAM USING
START POSITION
SOFTWARE VERSION
I
ndicates the door panel's software version.