84
Factory setting:
- Special codes: Bear in mind the number of digits in the code (see p. ).73
Administrator pin: 271800. 2718 if the number of digits configured = 4.
CP1 push button code: 111100. 1111 if the number of digits configured = 4.
CP2 push button code: 222200. 2222 if the number of digits configured = 4.
Unlocking code: 333300. 3333 if the number of digits configured = 4.
- Number of digits in user and special codes: Programming field “0” (p. ).75
Step 2: “4”– 4 digit code.
- Setting relay 1: Programming field “4” (p. ).79
Step 3: “0” Impulse.
Step 4: “03” Activation time (seconds).
- Setting relay 2: Programming field “4” (p. ).79
Step 3: “0” Impulse.
Step 4: “03” Activation time (seconds).
- Setting relay 3: Programming field “4” (p. ).79
Step 3: “0” Impulse.
Step 4: “03” Activation time (seconds).
Setting the panic output: Programming field “4” (p. ).79
Step 3: “0” Impulse.
Step 4: “10” Activation time (seconds).
- Setting external push button PL1: Programming field “5” (p. 8 ).0
Step 3: “1” Enable/disable the functioning of the push button with button code CP1.
Step 4: “10” Activation time (seconds).
- Setting external push button PL2: Programming field “5” (p. 8 ).0
Step 3: “2” Enable/disable the functioning of the push button with button code CP2.
Step 4: “05” Activation time (seconds).
- Setting locking mode: Programming field “6” (p. 8 ).1
Step 2: “3” Maximum number of failed attempts to enter user pin.
.
Step 3: “03” Minimum time between failed attempts (minutes).
Step 4: “03” Duration of lock mode (minutes).
Step 5: “1” The panic output is activated during lock mode.
- Setting identification ID: Programming field “7” (p. 8 ).2
Step 2: “000” Identification ID.
- Setting field depth: Programming field “8” (p. 8 ).2
Step 2: “3” field depth.
Step 3: “0” Direct call disabled.
- Setting the keypad beep: Programming field “9” (see p. ).83
Step 2: “1” Beep when keypad buttons pressed (activated).
AUDIO AND VIDEO DOOR ENTRY SYSTEM - CODED DOOR PANEL
PROGRAMMING THE DOOR PANEL
To Next Page
Loading...
