77
Programming fields:
Continued from previous page
2
Field “2”: Changing special codes.
Press “2” to select field “2”.
Steps: Field special code + code + key button+ .
3 C
or
( 1)Step
( 5)Step
Set the special code to select for subsequent code changes. Enter one of the
following options:
"0" : Select the administrator pin.
"1" : Select the CP1 button code.
"2" : Select the CP2 button code.
"3" : Select the unlock button code.
Allows the current code of the special codes to be changed (see p. ). The new special code must have the same73
number of digits as the current code.
Duplicate special codes are not allowed.
Note: Depending on the number of digits configured in field “0” (factory setting = 4).
Number of digits = 4, special codes from “0000” to “9999”.
Number of digits = 5, special codes from “00000” to “99999”.
Number of digits = 6, special codes from “000000” to “999999”.
0 0
0
( 3)Step
Set a new code number. Possible special codes: “000000” to “999999” with “6” digits.
Factory setting of “4” digits: “0000” to “9999” (see example of number of digits on
75p. , step 2).
Duplicate special codes are not allowed.
0
( 4)Step
Press the key button to finish programming the field.
Then press the number of the next field to configure or press the C button (cancel) to exit
programming mode.
2
0
0 0 00 1 2
or or
3
or
2 3
1
( 2)Step
0
or or or
AUDIO AND VIDEO DOOR ENTRY SYSTEM - CODED DOOR PANEL
PROGRAMMING THE DOOR PANEL
To Next Page
Loading...
Need help?
General
