GRAPHTEC CE7000-60 - Page 104

CE7000-UM-251-9370 7-30
7 DISASSEMBLY AND REASSEMBLY
How to reinstall the Y-motor
(1) Attach the Y-motor pulley to the Y-motor at the following position.
Y motor
Y motor pulley
1.5 mm
(2) Tighten the two M3L4WP set screws that hold the Y-motor pulley.
(3) Spread a suitable quantity of Loctite 222 on the two M3L4WP set screws that hold the Y-motor pulley.
(4) Attach the Y-motor to the Y-motor bracket.
(5) Hang the Y-drive belt on the Y-motor pulley and the Y-drive pulley.
(6) Perform the Y-drive belt tension adjustment (Refer to subsection 7.3.2.).
(7) Reattach the other parts in the reverse order in which they were detached.
(8) Conrm the wiring for Y motor cables (Refer to subsection 7.4.).