CE7000-UM-251-9370 8-55
8 Electrical Adjustment
8.18 Setting the Number of Push Rollers (CE7000-130/160)
This will set the number of push rollers.
Perform this procedure if adjustment values could not copy from the SUB-NVRAM when replacing the main
board.
When the main board or the optional push roller was installed, perform this adjustment.
How to set the number of push rollers
(1) Turn on the power while pressing the SLOW and the ENTER keys.
(2) The plotter displays the following menu.
(3) Press the PAUSE/MENU key to display the following menu.
(4) Press the Right position key to display the following menu.
(5) Press the down position key until the following menu is displayed.
(6) Press the F4 key to display the following menu.
(7) Sets the number of push rollers by the Up or Down position key.
To Next Page
Loading...
