GRAPHTEC CE7000-60 - 3.3 Setting the Origin Point

CE7000-UM-251-9370 7-37
7 DISASSEMBLY AND REASSEMBLY
7.2.14 Replacing the Fan
CE7000-40/60
How to detach the vacuum fan
(1) Detach the right side cover (Refer to subsection 7.1.1.).
(2) Detach the front guide (Refer to subsection 7.1.5.).
(3) Disconnect the cable of vacuum fan from the J1007 connector on the main board.
(4) Remove the two M3L35 binding head screws holding the vacuum fan as shown in the gure below.
M3L35 binding head screw
Fan
(5) Detach the vacuum fan from the front of CE7000-40/60.
How to reinstall the fan
(1) Reattach in the reverse order in which it was detached.