GRAPHTEC CE7000-60 - Attaching a Tool; Attaching a Tool for CE7000-40;60;130;160

CE7000-UM-251-9370 3-9
3 PARTS NAMES and FUNCTIONS
3.2 Attaching a Tool
Attach a tool (cutter pen, plotter pen) to the plotter�
3.2.1 Attaching a Tool for CE7000-40/60/130/160
Attaching a Tool
When mounting the tool in the tool holder, push the tool all the way into the holder until its ange contacts
the upper part of the holder and then tighten the screw rmly. To prevent injury, avoid touching the tool
immediately after the cutting plotter is turned on or whenever the tool is moving� It is explained here using
cutter pen as an example�
Procedure
(1) Loosen the pen holder screw�
Tool holderBracket to hold tool
Bracket to hold tool
Tool holder
Top
(2) While pushing the tool holder in the upward direction, push the tool all the way into the holder until its
ange contacts the upper part of the holder.
• When pushing the tool holder with your ngers, the blade tip may be protruding. Take care not to cut
your ngers.
Flange
Bracket to hold tool
Tool holder
(Backward: Half cutting/Plotting Pen)
Tool holder
(Forward: Using cutting)
Tool holder
Seen from above