GRAPHTEC CE7000-60 - Upgrading the System Firmware

CE7000-UM-251-9370 8-10
8 Electrical Adjustment
8.6 Upgrading the System Firmware
Toupgradethesystemrmware,preparethefollowingitems.
CE7000-40/60/130/160
• Windows PC :ThermwareisabletoupdatefromtheWindowsPConly.
• USB cable
• CE7000_V***_R****.X :CE7000rmware
• SEND.EXE   :UtilitytotransferlesusingWindows
®
• OPS662 :USB Driver software for the CE7000 (version must later than V3.70.)
CE7000-130AP
• Windows PC :ThermwareisabletoupdatefromtheWindowsPConly.
• USB cable
• CE7000AP_V***_R****.X :CE7000APrmware
• SEND.EXE   :UtilitytotransferlesusingWindows
®
• OPS628 :USB Driver software for the CE7000AP (version must later than V10.30.)
Preparation
(1) CopythermwareleontothePC.
(2) Copy the SEND.EXE onto the PC.
(3) Install the Windows Driver to the PC before connecting the CE7000 to the PC.
(4) Connect the PC and CE7000 via the USB port after the Windows driver was installed.
How to upgrade the system rmware
(1) Turn off the power for the CE7000 if power was turned on.
(2) Turn on the power while pressing the LEFT and RIGHT position keys.
Or after turning on the power, press the LEFT and the RIGHT position key simultaneously within 2
seconds.
(3) The plotter displays the following menu.