GRAPHTEC CE7000-60 - Replacing the Pen Block

CE7000-UM-251-9370 7-18
7 DISASSEMBLY AND REASSEMBLY
7.2.6 Replacing the Pen Block
How to detach the pen block
(1) Detach the right side cover (Refer to subsection 7.1.1.).
(2) Detach the control panel assembly (Refer to subsection 7.1.3.).
(3) Detach the center cover (Refer to subsection 7.1.4.).
(4) Detach the pen block cover (Refer to subsection 7.1.10.).
(5) Disconnect the cables from connector J3004, and J3006 on the Y-relay board.
(Disconnect the exible cable from connector J3004 for the CE7000-130AP)
Disconnect these cables.
CE7000-40/60
Pen board (Y relay board)
CE7000-130/160
Disconnect these cables.
Pen board (Y relay board)
(6) Remove the two M4L6 binding head screws attaching the pen block, and then detach the pen block
from the Y slider.
M4L6 binding head screw
Pen block