CE7000-UM-251-9370 3-3
3 PARTS NAMES and FUNCTIONS
3.1.2 Parts Names and Functions for CE7000-60
Front View
Cutting mat
Grit roller position guide
Cutting groove
Tool carriage
Tool holder
Control panel
Media set lever
USB interface connector
USB memory connector
RS-232C interface connector
Push rollers
Media sensors
Grit rollers
Network (LAN) Interface
connector
Media stopper
Control panel ���������������������������Used to access various plotter functions�
Push rollers ������������������������������Rollers that push the media against the grit rollers�
Grit rollers ��������������������������������Feeds the media back and forth�
Media sensors��������������������������The front sensor is used to sense the leading edge of the media� The rear
sensor is used to sense the trailing edge of the media�
Tool carriage ����������������������������Moves the cutter-pen or plotting pen across the media during cutting or
plotting�
Tool holder �������������������������������Holds the cutter-pen or plotting pen and moves it up or down�
Grit roller position guide ���������A roller position guide is affixed to the front side of the rail, which shows the
position of each grit roller� Use these alignment marks as an aid in locating
the Push rollers�
Cutting mat �������������������������������The cutter blade moves on this cutting mat�
Cutting groove �������������������������Use this groove to cut out (die cut) or cross cut�
Media set lever �������������������������Used to raise or lower the Push rollers during the loading or unloading of
media�
USB interface connector���������Used to connect the plotter to the computer with a USB interface cable�
RS-232C interface connector �Used to connect the plotter to the computer with a RS-232C interface cable�
It depends on the sales area� For details, please contact the distributor
where you purchased�
Media stopper ��������������������������This stops the stock shaft from spinning when setting in media� It is utilized
when pulling roll media straight out�
To Next Page
Loading...
