GRAPHTEC CE7000-60 - Adjusting the Offset of Registration Mark Sensor; Inputting the Registration Mark Sensor Offset Position from the Recorded Values

CE7000-UM-251-9370 8-32
8 Electrical Adjustment
8.14 Adjusting the Offset of Registration Mark Sensor
This adjustment will set the offset of tool and the registration mark senor position.
Preparation
When the registration mark sensor was replaced or removed, print out the target sheet which is on the last
pageofthischaptertoA4sizewhitecopypaper.
AUTO REGISTRATION MARK TARGET
The specification of the cross mark is 30 mm line length, and 0.3 to 0.5mm line width.
8.14.1 Inputting the registration mark sensor offset position from the
recorded values
Perform this procedure if adjustment values could not copy from the SUB-NVRAM when replacing the main
board was replaced or detached.
Input the offset value from the recorded values.
How to input the registration mark sensor offset position from the recorded values
(1) Turn on the power while pressing the SLOW and the ENTER keys.
(2) The plotter displays the following menu.
(3) Press the PAUSE/MENU key to display the following menu.