GRAPHTEC CE7000-60 - 8 Electrical Adjustment; List of Items Requiring Readjustment

CE7000-UM-251-9370 8-1
8 Electrical Adjustment
8 Electrical Adjustment
8.1 List of Items Requiring Readjustment
If you replaced any of the units listed in the table below or altered their sensor positions, be sure to readjust
the corresponding items.
Unit name
Item
Main board
Cam
sensor
board
Registration
mark
sensor
Pen
block
Media
sensor
X,Y
motor
Drive
roller
X,Y
drive
belt
Y belt
NOV-RAM clear M
DIP switch setting M
Firmware update M
Copy the adjustment value to main board M
Pen force adjustment N M
Distance adjustment N N N N
Registration mark sensor sensitivity adjustment N M M
Registration mark sensor offset adjustment M M
2-Pen adjustment (CE7000-130AP) N M
Media sensor position adjustment N M
Backup for the adjustment values N M
Belt tension adjustment M M M M
No mark: Unnecessary M: Must always be adjusted N: To be adjusted as necessary
Note: Themainboardmusthavethelatestversionofrmwareunlessotherwisespecied.