GRAPHTEC CE7000-60 - When the Cam Sensor Board was Replaced; When the 2 Nd Pen of Holder or Station was Replaced; When the Optional Push Roller was Installed; When the Gird Roller was Replaced

CE7000-UM-251-9370 8-5
8 Electrical Adjustment
8.2.6 When the cam sensor board was replaced
When the cam sensor board was exchanged, perform the following adjustment.
Back up the adjustment value to the SUB-NVRAM (Refer to subsection 8.19.).
End of adjustment
8.2.7 When the 2nd pen of holder or station was replaced
The CE7000-130AP only.
When the 2nd pen of holder or station was replaced, perform the following adjustment.
Adjust the 2nd Pen Exchange position (Refer to subsection 8.16.2.).
Adjust the Spacing Between Tool 1 and Tool 2 (Refer to subsection 8.17.2.).
End of adjustment
8.2.8 When the optional push roller was installed
The CE7000-130/160 only.
When the optional push roller was installed, perform the following adjustment.
Set the Number of Push Rollers (Refer to subsection 8.18.)
End of adjustment
8.2.9 When the gird roller was replaced
When the gird roller was replaced, perform the following adjustment.
Adjust the Distance and the Perpendicularity Accuracy adjustment values (Refer to subsection 8.12.2.).
End of adjustment