GRAPHTEC CE7000-60 - Attaching a Tool and a Pen for CE7000-130 AP

CE7000-UM-251-9370 3-11
3 PARTS NAMES and FUNCTIONS
3.2.2 Attaching a Tool and a Pen for CE7000-130AP
Attaching a Tool
When mounting the tool in the tool holder, push the tool all the way into the holder until its ange contacts
the upper part of the holder and then tighten the screw rmly. To prevent injury, avoid touching the tool
immediately after the cutting plotter is turned on or whenever the tool is moving� It is explained here using
cutter pen as an example�
The tool holder is suitable only for use with the cutter plunger� Please refrain from attaching the plotting pen
to it�
Tool holderBracket to hold tool
Top
Tool holder (Forward)
This position of tool holder is
not able to set tool (backward).
Procedure
(1) Loosen the pen holder screw�
Tool holderBracket to hold tool
Bracket to hold tool
Tool holder
Top