CE7000-UM-251-9370 3-12
3 PARTS NAMES and FUNCTIONS
(2) While pushing the tool holder in the upward direction, push the tool all the way into the holder until its
ange contacts the upper part of the holder.
• When pushing the tool holder with your ngers, the blade tip may be protruding. Take care not to cut
your ngers.
Flange
Bracket to hold tool
Tool holder (Forward)
Tool holder
Top view
This position of tool holder is
not able to set tool (backward).
(3) Make sure that the tool bracket is engaged on the tool’s ange, and then tighten the screw.
FlangeBracket to hold tool
To Next Page
Loading...
