GRAPHTEC CE7000-60 - Replacing the Y-Motor

CE7000-UM-251-9370 7-28
7 DISASSEMBLY AND REASSEMBLY
7.2.11 Replacing the Y-motor
How to detach the Y-motor
(1) Detach the right side cover (Refer to subsection 7.1.1.).
(2) Disconnect the Y-motor encoder cables from Y motor.
(3) Disconnect the Y-motor power cable from Y motor power relay cable connector.
(4) Mark the position of screws which are holding the Y motor as shown in the picture below.
Y Motor
CE7000-40/60
Mark the position of screws
which are holding the Y motor.
Mark the position of screws
which are holding the Y motor.
CE7000-130/130AP/160
Y Motor