GRAPHTEC CE7000-60 - Replacing the Y-Belt

CE7000-UM-251-9370 7-20
7 DISASSEMBLY AND REASSEMBLY
7.2.7 Replacing the Y-belt
How to detach the Y-belt
(1) Detach the right side cover (Refer to subsection 7.1.1.).
(2) Detach the left side cover (Refer to subsection 7.1.2.).
(3) Detach the control panel assembly (Refer to subsection 7.1.3.).
(4) Detach the center cover (Refer to subsection 7.1.4.).
(5) Detach the pen block (Refer to subsection 7.2.6.).
(6) Remove the Y belt tension spring from the Y belt tension arm.
Y belt tension spring
Y belt tension arm
CE7000-40/60
Y belt tension spring
Y belt tension arm
CE7000-130/130AP/160
(7) Loosen the M4L6 TP screws xing the Y-belt tension for the CE7000-40/60.
Loosen the two M4L6 TP screws xing the Y-belt tension for the CE7000-130/130AP/160.
Tension xing screw
Tension xing screw
CE6000-40/60
CE6000-130/130AP/160