GRAPHTEC CE7000-60 - Adjusting the Spacing between Tool 1 and Tool 2 (CE7000-130 AP); Inputting the Spacing between Tool 1 and Tool 2 from the Recorded Value; Adjusting the Spacing between Tool 1 and Tool 2

CE7000-UM-251-9370 8-49
8 Electrical Adjustment
8.17 Adjusting the Spacing Between Tool 1 and Tool 2 (CE7000-130AP)
This adjustment will set the spacing between tool 1 and tool 2.
8.17.1 Inputting the Spacing Between Tool 1 and Tool 2 from the recorded value
Perform this procedure if adjustment values could not copy from the SUB-NVRAM when replacing the main
board.
How to input the Spacing Between Tool 1 and Tool2
(1) Turn on the power while pressing the SLOW and the ENTER keys.
(2) The plotter displays the following menu.
(3) Press the PAUSE/MENU key to display the following menu.
(4) Press the Right position key to display the following menu.
(5) Press the Down position key until the following menu is displayed.
(6) Press the F1 key to display the following menu.