CE7000-UM-251-9370 8-50
8 Electrical Adjustment
(7) Press the F3 key to display the following menu.
Set the X-offset value by using the UP or DOWN position key.
(8) Input the X-offset value from the recorded.
(9) Press the ENTER key after offset value is input, the following menu is displayed.
(10) Press the F4 key to display the following menu.
Set the Y-offset value by using the UP or DOWN position key.
(11) Input the Y-offset value from the recorded.
(12) Press the ENTER key after offset value is input, the following menu is displayed.
(13) Press the ENTER key, the following menu is displayed.
(14) Turn off the power for the plotter. (When other adjustment is going to perform continuously it does not
need to turn off the power.)
To Next Page
Loading...
