GRAPHTEC CE7000-60 - 8.1 Sorting the Cutting Data

CE7000-UM-251-9370 8 -51
8 Electrical Adjustment
8.17.2 Adjusting the Spacing Between Tool 1 and Tool 2
When the pen block was replaced or the 2nd Pen was removed, perform this adjustment.
Preparation
• Preparethetwobertip-pens(KF700-BK)andthebertip-penplunger(PHP31-FIBER).
Installthebertip-pens(KB700-BK)tothebertip-penplunger(PHP31-FIBER)correctly,thelengthfortip
ofbertip-peisimportanttodetectthepens.
How to adjust the spacing between tool 1 and tool 2
(1) Turn on the power while pressing the SLOW and the ENTER keys.
(2) The plotter displays the following menu.
(3) Load the copy paper to the plotter, and then the plotter displays the following menu.
(4) Press the 3 key (SHEET) to display the following menu.
(5) Press the PAUSE/MENU key to display the following menu.
(6) Press the Right Position key to display the adjustment menu shown below.
(7) Installthebertippenstothetool1holder(Theforntsideistool1fortheCE7000-130AP.)andthe2nd
pen station (Right side plate of holder).