CE7000-UM-251-9370 8-54
8 Electrical Adjustment
(21) Press the ENTER key after offset value is input, the following menu is displayed.
(22) Press the F2 key. Verify that the plotted pen 1 cross mark is located at the center of the plotted pen 2
lines.
Use the Position keys to move the pen to an open area to plot the adjustment pattern.
(23) If the plotted cross marks are in the correct positions, press the ENTER key to store the setting and
complete the adjustment.
(24) Press the ENTER key, the following menu is displayed.
(25) Turn off the power for the plotter. (When other adjustment is going to perform continuously it does not
need to turn off the power.)
To Next Page
Loading...
